1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
|
//
// main.ino
//
// This software is intended to be run on a small Arduino (e.g., a Pro Mini),
// whose purpose is dedicated to talking to the RC system. That is to say, it
// listens to the PPM signal from the RC receiver and produces a compatible
// single for the ESCs to control the motors. It additionally talks to the main
// board via a trivial serial protocol. In so doing, this software relieves the
// main board (and software running on it) of the task of interfacing with any
// of the RC system.
//
// Receiver
// --------
//
// The 8 channels (from the RC receiver) need to be combined and fed to two
// interrupts on the Arduino. They need to be combined in such a way as to
// alternate pulses between the two interrupts (which are alternately used to
// read the pulses). Like this:
//
// ch1 ch3 ch5 ch7 ch2 ch4 ch6 ch8
// | | | | | | | |
// ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼
// ¯ ¯ ¯ ¯ ¯ ¯ ¯ ¯
// ___ | | | | | | | | ___
// GND ---|___|---+----+----+----+ +----+----+----+----|___|--- GND
// R | | R
// ____________________ | __ | _____________________
// | |
// pin 2 o o pin 3
// (interrupt 0) (interrupt 1)
//
// The two resistors in the circuit are pull-down resistors (so, say 100kΩ).
// Without them, the Arduino is unable to read the pulse wave at all.
//
// Note that your receiver may not send pulses sequentially, in "channel order".
// If this turns out to be the case, you will need to arrange for the pulses to
// wire up the channels in an order whereby the pulses alternatively alternately
// between the two interrupts and adjust the channel order below.
//
// Motor control
// -------------
//
//
#include "config.h"
#include "receiver.h"
#include "motors.h"
#include "testing.h"
void setup()
{
Receiver::setup();
Motors::setup();
Testing::setup();
}
void loop()
{
unsigned long channel_values[ NUM_CHANNELS ];
while( true )
{
if( Receiver::read_channels( channel_values ) )
{
Testing::draw_receiver_channels( channel_values );
}
// Motors::update_channels( channel_values );
}
}
|